Where can you determine the default gateway address?
Where can you determine the default gateway address?
what can the ERX Edge Router possibly negotiate?
When sending an LCP Configuration Request, what can the ERX Edge Router possibly negotiate?
What does a BGP route reflector do when reflecting a route?
What does a BGP route reflector do when reflecting a route?
Which three conditions can exist if the default gateway is learned using the WX device’s local interface
Which three conditions can exist if the default gateway is learned using the WX device’s local
interface? (Choose three.)
Which two prefixes would summarize the networks shown below?
Which two prefixes would summarize the networks shown below? (Choose two.)
192.168.1.0/24
192.168.2.0/24
192.168.3.0/24
Which two common issues cause AppFlow not to work?
Which two common issues cause AppFlow not to work? (Choose two.)
Which set of configuration commands accurately completes this task?
You would like to configure a Frame Relay interface with the following characteristics: ?
Serial interface 4/0:3/1 ?
192.168.9.2/24 ? PVC – 16 ? DCE
Which set of configuration commands accurately completes this task?
What are two typical results you can see when AppFlow is not accelerating correctly?
What are two typical results you can see when AppFlow is not accelerating correctly? (Choose two.)
which two methods are available for dynamically allocating an IP address to the customer’s device?
In a PPP over ATM service offering, which two methods are available for dynamically allocating an
IP address to the customer’s device? (Choose two.)
Which type of NAT is configured in the exhibit?
Review Below:
[edit security nat destination]
user@host# show
pool A {
address 10.1.10.5/32;
}
rule-set 1 {
from zone untrust;
rule 1A {
match {
destination-address 100.0.0.1/32;
}
then {
destination-nat pool A;
}
}
}
Which type of NAT is configured in the exhibit?