which LSP is being used to forward packets?
In your RSVP network you have configured three separate LSPs to the same egress address. You
have made no other configuration changes to the forwarding decisions made by the router. Which
commands can you use to determine which LSP is being used to forward packets?
Which two values are used by an RSTP bridge to remove stale BPDU information?
Which two values are used by an RSTP bridge to remove stale BPDU information? (Choose two.)
Which two statements describe the difference between Junos software for security platforms and a traditional r
Which two statements describe the difference between Junos software for security platforms
and a traditional router? (Choose two.)
what happens to frames that arrive that contain unknown unicast destination addresses?
Click the Exhibit button.
After the MAC learning limit of 3000 is reached for the bd bridge domain as shown in the exhibit,
what happens to frames that arrive that contain unknown unicast destination addresses?
What does this mismatch indicate?
You have recently configured MSTP on two switches in your network to participate in the same
MSTP region. You issue the show spanning-tree mstp configuration command on both switches
and notice that the configuration digests do not match. What does this mismatch indicate?
what happens to the existing and new sessions when you change the policy action from permit to deny?
Using a policy with the policy-rematch flag enabled, what happens to the existing and new
sessions when you change the policy action from permit to deny?
Which statement is correct about this scenario?
You have a stub OSPF area running in your network. Your supervisor has asked you to build a
virtual link across this area to connect new equipment acquired in a recent ISP acquisition. Which
statement is correct about this scenario?
Which prefix would your ISP likely allocate to your company?
You own a small company and need to assign IPv6 addresses to your routers. Because you want
to follow the guidelines spelled out in RFC 3177, you want to design your network with the correct
prefixes. Which prefix would your ISP likely allocate to your company?
Which two content-filtering features does FTP support?
Which two content-filtering features does FTP support? (Choose two.)
Which solution will meet these requirements?
Your customer would like to forward traffic using DLCI 600 and maintain Layer 2 information
across a VPN. Which solution will meet these requirements?