Which two types of traffic does the Host Checker connection control policy block on the client?
Which two types of traffic does the Host Checker connection control policy block on the client?
(Choose two.)
Which type of route would be suited for this scenario?
You have been asked to define a default gateway for traffic leaving a router. This route should use
interface so-0/0/0 as its next-hop. Which type of route would be suited for this scenario?
Which configuration statement would correctly accomplish this task?
A network administrator wants to permit Telnet traffic initiated from the address book entry
the10net in a zone called UNTRUST to the address book entry Server in a zone called
TRUST. However, the administrator does not want the server to be able to initiate any type
of traffic from the TRUST zone to the UNTRUST zone.Which configuration statement would
correctly accomplish this task?
how many full OSPF adjacencies will R3 have?
Click the Exhibit button
In the exhibit, how many full OSPF adjacencies will R3 have?
which role mapping rule type will perform this operation?
Certain users within your organization have an LDAP attribute named userAttr.EmployeeLevel. You
want to map these users to a specific role if the value of the attribute is 65 or higher. In the Admin
UI, which role mapping rule type will perform this operation?
Which type of protocol would you consider in your design?
You are asked to design a Layer 2 switched topology that can automatically recover from link
failures.
Which type of protocol would you consider in your design?
which three functions?
The MAG Series Junos Pulse Gateway provides which three functions? (Choose three.)
Which command do you use to manually remove antivirus patterns?
Which command do you use to manually remove antivirus patterns?
which routes in the forwarding table will begin load-balancing packet flows?
Click the Exhibit button
When the Junos configuration shown in the exhibit is applied to the router, which routes in the
forwarding table will begin load-balancing packet flows?
Which two statements reflect potential causes for this issue?
You have configured MPLS and RSVP in your network using all of the Junos defaults. You
established an LSP in your network which is reporting an up status but no traffic is using it.
Which two statements reflect potential causes for this issue? (Choose two)