Which statistics counter shows that a server connecting to a server Node group is asserting flow control?
Which statistics counter shows that a server connecting to a server Node group is asserting flow
control?
Which three BGP attributes are used for loop prevention?
Which three BGP attributes are used for loop prevention? (Choose three.)
What are two reasons for this behaviour?
You have recently brought up a QFabric system and now see all of the expected components within
the system’s inventory. After performing some initial configuration tasks, including the definition of
the Node-2:ge-0/0/13 interface, you issue the show interfaces terse command and do not see the
defined interface. What are two reasons for this behaviour? (Choose two.)
Which three attributes would you use at this point?
You require all users on the MAG Series Junos Pulse Gateways device to connect to the company
network using client certificates as part of the authentication. You configure this requirement under
Users > User Realms > MyRealm > Auth Policy. For the presented certificates, you require specific
values in the client certificates. Which three attributes would you use at this point? (Choose three.)
Which three Routing Engine types ensure that Node devices participating in the same VLAN are aware of all othe
Which three Routing Engine types ensure that Node devices participating in the same VLAN are
aware of all other Node devices in that VLAN? (Choose three.)
Which two statements in a source NAT configuration are true regarding addresses, rule-sets, or rules that over
Which two statements in a source NAT configuration are true regarding addresses, rule-sets,
or rules that overlap? (Choose two.)
Which two BGP attributes will affect this behavior?
You are attempting to influence return traffic into your autonomous system by preferring one router
as an entry point.
Which two BGP attributes will affect this behavior? (Choose two.)
What will cause this condition?
You are installing a QFX3000-G QFabric system. Upon system boot, you notice that no Node devices
are connected to the system. What will cause this condition?
Which command should you use?
You need to determine whether there have been core dumps from the fabric administrator within
the last 24 hours. Which command should you use?
which two Juniper Networks services?
The Junos Pulse client connects to which two Juniper Networks services? (Choose two.)