what are two solutions?
Click the Exhibit button.
Your employer is ISP A. Your customers must be able to reach customers of both ISP B and ISP
C, but your network must not allow transit traffic between ISP B and ISP C at any time. Referring
to the exhibit, what are two solutions? (Choose two.)
which port is used to send state synchronization information to other devices in the cluster?
In IDP Sensor clustering, which port is used to send state synchronization information to other
devices in the cluster?
which statement is true about transit traffic sent to 2.2.2.2?
Click the Exhibit button.
— Exhibit —
user@R1> show route 2.2.2.2
user@R1> show route forwarding-table destination 2.2.2.2
Routing table: default.inet
Internet:
Destination Type RtRef Next hop Type Index NhRef Netif
2.2.2.2/32 user 1 17.1.1.2 ucst 642 9 xe-1/1/0.0
— Exhibit —
Referring to the exhibit, which statement is true about transit traffic sent to 2.2.2.2?
What will accomplish this?
Click the Exhibit button.
You are asked to configure an OSPF network based on the topology shown in the exhibit. Area 1
must not receive Type 5 LSAs from the backbone, but must be capable of containing ASBRs.
What will accomplish this?
What is required to support policy-based NAT when using route-based VPNs?
What is required to support policy-based NAT when using route-based VPNs?
where are the two policies going to be required?
Click the Exhibit button.
In this route-based VPN configuration, where are the two policies going to be required?
(Choose two.)
Which two statements are valid?
Click the Exhibit button.
In the exhibit, NG-MVPN is used for a Layer 3 VPN. Which two statements are valid? (Choose
two.)
What is required to support policy-based NAT when using route-based VPNs?
What is required to support policy-based NAT when using route-based VPNs?
which statement is true about transit traffic sent to 2.2.2.2?
Click the Exhibit button.
— Exhibit —
user@R1> show route forwarding-table destination 2.2.2.2
user@R1> show route 2.2.2.2
inet.0: 10 destinations, 10 routes (10 active, 0 holddown, 0 hidden)
+ = Active Route, – = Last Active, * = Both
2.2.2.2/32 *[OSPF/10] 2w3d 22:19:41, metric 1
> to 17.1.1.2 via xe-1/1/0.0
— Exhibit —
Referring to the exhibit, which statement is true about transit traffic sent to 2.2.2.2?
Which statement is correct about tunnel interfaces?
Which statement is correct about tunnel interfaces?