Which command is used to avoid IP fragmentation when configuring IPSec on a ScreenOS device?
Which command is used to avoid IP fragmentation when configuring IPSec on a ScreenOS
device?
Which two Layer 2 VPN technologies will meet this requirement?
You are asked to design a Layer 2 VPN service for a service provider network that supports
Ethernet and ATM transport. Which two Layer 2 VPN technologies will meet this requirement?
(Choose two.)
Which is NOT a likely reason for the failure?
You are looking at the event log of the responding device and it says
Rejected an initial Phase 1 packet from an unrecognized peer gateway
Which is NOT a likely reason for the failure?
which two statements are true about the chassis?
Click the Exhibit button.
— Exhibit —
user@router> show chassis environment
Class Item Status Measurement
Power Power Supply A OK
Power Supply B Absent
Temp FPC 0 OK 28 degrees C / 82 degrees F
FPC 1 OK 27 degrees C / 80 degrees F
Power Supply A OK 22 degrees C / 71 degrees F
Power Supply B Absent
SSB 0 OK 30 degrees C / 86 degrees F
Backplane OK 22 degrees C / 71 degrees F
Routing Engine 0 OK 26 degrees C / 78 degrees F
Routing Engine 1 Testing
Fans Rear Fan OK Spinning at normal speed
Front Upper Fan OK Spinning at normal speed
Front Middle Fan OK Spinning at normal speed
Front Bottom Fan OK Spinning at normal speed
Misc Craft Interface OK
— Exhibit —
Referring to the exhibit, which two statements are true about the chassis? (Choose two.)
What action should be taken to fix the problem?
Your VPN is failing during Phase 2 communication. You check your local event log and do
not see anything to indicate why the failure occurred. What action should be taken to fix the
problem?
Which three statements are true regarding LDP Layer 2 circuit signaling?
An LDP Layer 2 circuit is configured for VPN A and VPN B. Which three statements are true
regarding LDP Layer 2 circuit signaling? (Choose three.)
What two (2) options should you check?
Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover
that there is no cookie. What two (2) options should you check?
What is likely to be the problem?
You are looking at the event log of the initiating device and it says
Received notify message for DOI <1> <14> <NO_PROPOSAL_CHOSEN>.
What is likely to be the problem?
Which configuration correctly provisions the interface?
You are provisioning a new customer for an LDP Layer 2 circuit. You have assigned them VLAN
600 on interface ge-1/0/0.Which configuration correctly provisions the interface?
which statement is true?
Click the Exhibit button.
— Exhibit —
user@host > show chassis craft-interface
Front Panel System LEDs:
Routing Engine 0 1
————————–
OK * .
Fail . *
Master * .
Front Panel Alarm Indicators:
—————————–
Red LED .
Yellow LED *
Major relay .
Minor relay *
Front Panel FPC LEDs:
FPC 0 1 2 3 4 5 6 7 8 9
—————————————————–
Red . . . . . . . . . .
Green * * . . . . . . * *
CB LEDs:
CB 0 1
————
Amber . .
Green * *
PS LEDs:
PS 0 1 2 3 4 5 6 7 8
————————————————-
Red . . . . . . . . .
Green . . . . * * * * *
Fan Tray LEDs:
FT 0 1 2 3
——————–
Red . . . .
Green * * * *
Front Panel SFB LEDs:
SFB 0 1 2 3 4 5 6 7
————————————
Red . . . . . . . .
Green * * * * * * * *
Front Panel Chassis Info:
Chassis Number 0x0
Chassis Role S
— Exhibit —
Referring to the exhibit, which statement is true?