Which command do you use to finish the configuration?
Click the Exhibit button.
You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across
both available links to ISP B’s network. Which command do you use to finish the configuration?
Which statement is true about packet capture in the IDP sensor?
Which statement is true about packet capture in the IDP sensor?
Which operational mode command should you issue?
You suspect that your router is missing the .0/24 routes for your local network. You first want to
look for the routes on the control plane before troubleshooting the data plane.
Which operational mode command should you issue?
which three (3) items?
An Access Policy must contain which three (3) items?
Which two statements are true?
Click the Exhibit button.
The exhibit shows the output of a Junos show bgp neighbor command. Which two statements are
true? (Choose two.)
Which choice will allow you to accomplish this?
You have just installed a new ScreenOS device in your network and you want only a select range of
IP addresses to have administrative access to the device.
Which choice will allow you to accomplish this?
which NetScreen device?
The CLI command, ‘set policy from untrust to trust “ANY” “ANY” “ANY” Permit’ is the default
configuration policy on which NetScreen device?
What will result in the largest number of policies being counted against the total policies allowed for the Ne
What will result in the largest number of policies being counted against the total policies
allowed for the Netscreen device?
which path will traffic from R6 take to reach R1?
Click the Exhibit button.
Referring to the OSPF link metrics in the exhibit, which path will traffic from R6 take to reach R1?
Which three must a policy contain?
Which three must a policy contain? (Choose three.)