Which routing table is used to store Layer 2 routing information on system components?

What is the function of a control plane switch in a QFabric system?

According to Juniper Networks recommendations, specific ports have been reserved on the EX4200
switches to connect to each of the QFX3000-M QFabric system device types. Which ports connect to
the Interconnect devices?

What is the function of an Interconnect device in a QFabric system?

What are two fiber optic cabling requirements for a data plane of a QFX3000-G QFabric system?
(Choose two.)

You are installing a QFX3000-G QFabric system. Upon system boot, you notice no Node devices show
as connected to the system. What are two explanations for this condition? (Choose two.)

Which statistics counter shows that a server connecting to a server Node group is asserting flow
control?

You have recently brought up a QFabric system and now see all of the expected components within
the system’s inventory. After performing some initial configuration tasks, including the definition of
the Node-2:ge-0/0/13 interface, you issue the show interfaces terse command and do not see the
defined interface. What are two reasons for this behaviour? (Choose two.)

Which three Routing Engine types ensure that Node devices participating in the same VLAN are
aware of all other Node devices in that VLAN? (Choose three.)

You are installing a QFX3000-G QFabric system. Upon system boot, you notice that no Node devices
are connected to the system. What will cause this condition?