— Exhibit — Click the Exhibit button. A customer is trying to configure a router to peer using
EBGP to a neighbor. As shown in the exhibit, two links are being used for this configuration.
The goal of this configuration is to loadbalance traffic across both EBGP links. Which
configuration accomplishes this goal?

— Exhibit — Click the Exhibit button. In the exhibit, R5 is receiving five 200.1.1.x routes from
the RIP router, and is advertising them into Area 1 using an export policy. You do not want
any of the RIP routes to be in the routing table of R1. Which two solutions meet this
requirement? (Choose two.)

— Exhibit — Click the Exhibit button. In the exhibit, a customer wants to configure an EBGP
connection to two different routers in a neighboring autonomous system. The goal of this
configuration is to use per-prefix load balancing across both EBGP links. Which
configuration accomplishes this goal?

— Exhibit — Click the Exhibit button. Referring to the exhibit, R4 in AS 100 is sending routes
20.0.0.0/8 and 10.0.0.0/8. R3 sees the routes but R5 does not. What must be configured on
the R3 router for the R5 router to install the routes?

— Exhibit — Click the Exhibit button. You are asked to configure an OSPF virtual link that
connects remote Area 4 to the backbone. Referring to the exhibit, what are two
requirements for an OSPF virtual link to operate correctly? (Choose two.)

— Exhibit — Click the Exhibit button. In the exhibit, R5 is receiving five 200.1.1.x routes from
the RIP router, and is advertising them into Area 1 using an export policy. You want to
summarize the RIP routes into Area 0 with the most specific prefix. Which configuration will
accomplish goal?

— Exhibit — Click the Exhibit button. Examine the output of the show bgp summary
command shown in the exhibit. From which BGP peer is the router receiving IPv6 routes?

— Exhibit — Click the Exhibit button. Host 1, Host 2, and Host 3 are connected to Switch A
on interface ge-0/0/2. Host 1 and Host 2 do not support 802.1X. They can authenticate and
connect to the Internet. Host 3 was added and it supports 802.1X; however, it is unable to
authenticate. Referring to the exhibit, how do you allow Host 3 to authenticate to the
network but maintain secure access?

— Exhibit — Click the Exhibit button. The CLI output shown in the exhibit was taken from the
RP in a PIM-SM network. Which statement explains the output shown in the exhibit?

— Exhibit — Click the Exhibit button. The exhibit shows the output of an OSPF router LSA.
Which interface ID represents the router’s loopback address?