— Exhibit – — Exhibit — Click the Exhibit button. You are asked to configure a new external
BGP peering. You have configured BGP on R1 as shown in the exhibit, however the BGP
peering remains in Active state. Which additional configuration is required on R1 to
establish the BGP peering?

— Exhibit — — Exhibit — Click the Exhibit button. R2 is exporting static routes to R1 using
BGP. R1 is not receiving one of the five static routes that is configured on R2. Referring to
the exhibit, what should be changed under the BGP configuration to resolve this issue?

— Exhibit — — Exhibit — Click the Exhibit button. You are asked to configure an EBGP
peering to AS 65002. The EBGP peering is stuck in a Connect state. Referring to the
exhibit, what should be changed to the BGP configuration to bring up the peering?

— Exhibit — — Exhibit — Click the Exhibit button. You have been asked to configure an EBGP
peering to AS 65002. The EBGP peering is stuck in an Active state. Referring to the exhibit,
what would be changed to bring up the peering?

— Exhibit – — Exhibit — Click the Exhibit button. In the exhibit, A1 sends a broadcast frame
with destination MAC address FFFF.FFFF.FFFF, and all other stations have sent a
response . What would be the correct MAC address table on the MX240? ge-0/0/0
0140.5501.1111

— Exhibit – — Exhibit — Click the Exhibit button. In the exhibit, all switches run STP;
however, the link between bridge G and bridge E fails. What does root bridge A do after it
receives information about this link failure?

— Exhibit – — Exhibit — Click the Exhibit button. Referring to the exhibit, you have an
established RSVP LSP between R1 and R5 when you experience a link failure between R2
and R4. Which two statements are correct? (Choose two.)

— Exhibit — — Exhibit — Click the Exhibit button. Referring to the exhibit, what is missing in
the configuration to make the Layer 3 VPN functional? (Choose two.)

— Exhibit — — Exhibit — Click the Exhibit button. In the exhibit, which configuration element is
missing to bring up the Layer 2 circuit?

— Exhibit – — Exhibit — Click the Exhibit button. Based on the exhibit, which configuration
will permit end-to-end routing through the GRE tunnel for R1?