What is the maximum number of custom proposals sent by a ScreenOS device when negotiating IKE Phase 1 or Phase
What is the maximum number of custom proposals sent by a ScreenOS device when negotiating IKE Phase 1 or Phase 2?
Which command is used to verify IKE Phase 1 is complete?
Which command is used to verify IKE Phase 1 is complete?
Which two statements are accurate about AH packets?
Which two statements are accurate about AH packets? (Choose two.)
What are three likely reasons for the failure?
You are looking at the event log of the responding device and it says, "Rejected an initial Phase 1 packet from an unrecognized peer gateway" What are three likely reasons for the failure? (Choose three.)
Which ScreenOS CLI command would be used to add services to an existing multi-cell policy?
Which ScreenOS CLI command would be used to add services to an existing multi-cell policy?
Which command is used when configuring web management on the VLAN1 interface for a client connected to an e3 i
Which command is used when configuring web management on the VLAN1 interface for a client connected to an e3 interface in the DMZ zone?
Which three commands are used to verify that routing is correctly configured?
Which three commands are used to verify that routing is correctly configured? (Choose three.)
What is the next logical troubleshooting step?
Your VPN is failing during Phase 2 negotiation, and you are the initiator. You check your local event log and see IPSec messages but no failures. What is the next logical troubleshooting step?
How should you configure your tunnel interface?
You want to minimize the number of IP addresses, subnets, and policies in use. How should you configure your tunnel interface?
how is the second packet handled differently than the first in a series of allowed interzone packets?
In the packet forwarding decision process, how is the second packet handled differently than the first in a series of allowed interzone packets?