By default, where are changes stored when a save command is issued from the CLI during a management session?

Which ScreenOS CLI command would be used to verify WebAuth authentication?

When changes are made to the running config during a WebUI management session, to what external hardware component can the changes be saved?

Your server at 10.1.2.50 is behind the ScreenOS device. You want to allow access to users from the Internet, but not allow the server to initiate sessions. The interface connected to the network is on a /30 subnet and is in the "Internet" zone. Your ISP has provided you with another /30 public subnet you can use for NAT. Which form of NAT would you use?

If all interfaces are configured for route mode, what will be modified by the ScreenOS device when traffic travels from the trust zone to the untrust zone?

You are configuring an interface in the untrust zone with an IP address, telnet enabled, and WebUI management. Which sequence of steps must be performed to make the interface operational at the end of the configuration sequence?

Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no cookie. Which two should be verified? (Choose two.)

What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)

Which ScreenOS CLI commands would be used to enable traffic logging in policy edit mode?

Which number is used by get event <number> to view all VPN events?