You are asked to design a Layer 2 switched topology that can automatically recover from link failures.

Which type of protocol would you consider in your design?

You have been asked to define a default gateway for traffic leaving a router. This route should use interface so-0/0/0 as its next-hop.Which type of route would be suited for this scenario?

What is the function of the hop limit field in the IPv6 header?

You have been asked to configure an IPv6 address for a group of interfaces that could belong on different routers. If a packet is sent to that address, it should be received by all routers in the group.

Which address type would be suited for these requirements?

Which BGP state denotes a fully operational session?

You have recently implemented a graceful Routing-Engine switchover (GRES) and want to further reduce down time if a Routing Engine (RE) failure occurs.

Which two features can be configured on this device to reduce its downtime in this situation? (Choose two)

You are logged into a router and have navigated to the [edit routing-options] level of the hierarchy. You have been asked to create a static route that will use 43 18 7 1 as its primary next-hop and 76 1310 2 as its secondary next-hop.

Which command correctly configures this setup?

Which role does the router ID (RID) have in the BGP route selection process?

Which two values displayed in the output from the show spanning-tree MSTP configuration command must match on all switches participating in the same MSTP region? (Choose two)

Which Junos operational mode command is used to verify that load balancing is working as expected?