Which configuration accomplishes this goal?
Click the Exhibit button.
In the exhibit, Site 1 is sending traffic on VLANs 100, 200, and 300.
The provider operating switch S1 must configure Q-in-Q tunneling to transport VLANs 100 and 200 to Site2.
The provider must configure switch S1 to block traffic received from site 1 on VLAN 300.
Which configuration accomplishes this goal?
what are two requirements for an OSPF virtual link to operate correctly?
Click the Exhibit button.
You are asked to configure an OSPF virtual link that connects remote Area 4 to the backbone.
Referring to the exhibit, what are two requirements for an OSPF virtual link to operate correctly? (Choose two.)
Which statement explains the output shown in the exhibit?
Click the Exhibit button.
The CLI output shown in the exhibit was taken from the RP in a PIM-SM network.
Which statement explains the output shown in the exhibit?
What must be configured on the R3 router for the R5 router to install the routes?
Click the Exhibit button.
Referring to the exhibit, R4 in AS 100 is sending routes 20.0.0.0/8 and 10.0.0.0/8. R3 sees the routes but R5 does not.
What must be configured on the R3 router for the R5 router to install the routes?
How do you solve this problem?
Click the Exhibit button.
The phone connected to switch-1 in the exhibit cannot communicate with the rest of the network.
How do you solve this problem?
Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?
Click the Exhibit button.
In the exhibit, Source is sending multicast traffic to the multicast group address ffbe::1.
Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?
Which link will not be on the RPT?
Click the Exhibit button.
In the PIM-SM network in the exhibit, all links in the topology have the same IGP metric configured.
Which link will not be on the RPT?
Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol (CDP), but bloc
Click the Exhibit button.
In the exhibit, switches S1, S2, and S3 have Q-in-Q tunneling configured between Site 1 and Site 2.
Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol (CDP), but blocks VLAN Trunking Protocol (VTP) between Site 1 and Site 2?
why are the OSPF routers stuck in Init state?
Click the Exhibit button.
Looking at the trace options output in the exhibit, why are the OSPF routers stuck in Init state?
why is the BGP neighbor not in Established state?
Click the Exhibit button.
Looking at the output in the exhibit, why is the BGP neighbor not in Established state?