Click the Exhibit button.

In the exhibit, the data center is using VSTP.

The data center network is experiencing outages due to spanning tree instabilities between the recently installed virtual switches and the data center Layer 2 domain.

Which action resolves the spanning tree instabilities without impacting connectivity?

Click the Exhibit button.

Referring to the exhibit and based on the output below from Sw-1 and Sw-2, which statement is true?

Click the Exhibit button.

The four routers in the exhibit are participating in a multi-area OSPF topology.
Node B (in the upper right-hand corner) is an ASBR advertising an external route.
Node A (lower left-hand corner) receives the external route and begins to forward traffic to the ASBR.

How many hops will the packets take through this topology? (Do not count node A.)

Click the Exhibit button.

As shown in the exhibit, the 10.10/16 prefix is redistributed into OSPF through R2 and R5.

R2 and R5 are advertising the prefix with a Type 2 metric of 100.

What is the preferred path to reach 10.10/16 from R6?

Click the Exhibit button.

Looking at the traceoptions output, what is the current keepalive timer set for in BGP?

Click the Exhibit button.

Host 1, Host 2, and Host 3 are connected to Switch A on interface ge-0/0/2.
Host 1 and Host 2 have been authenticated through 802.1X, however Host 3 does not have an 802.1X supplicant.

Referring to the configuration in the exhibit, how can Host 3 be authenticated?

Click the Exhibit button.

In the exhibit, the 10.100/16 prefix is introduced at autonomous system 1 (AS1) and propagated through to AS3.
Router A in AS3 receives two different paths to these prefixes, one through AS2 and the other through AS4.
No BGP attributes have been altered.

Which path would router A prefer for the 10.100/16 prefix?

Click the Exhibit button.

In the exhibit, the 67.43.142/24 route is advertised using BGP to ISPs A and C. No policies have been applied.

How will ISP B choose its best BGP route between ISP A and ISP C?

Click the Exhibit button.

Your company is integrating another OSPF area into your existing OSPF infrastructure.

You created a virtual link that spans Area 2 and connects Area 3 to the backbone area.

Based on the exhibit, what is preventing the adjacency?

Click the Exhibit button.

Based on the configuration in the exhibit, which routing table is used for IPv4 multicast RPF checks?