which statement is correct?
Click the Exhibit button.
Based on the configuration in the exhibit, which statement is correct?
What are two ways to do this?
Click the Exhibit button.
In the exhibit, ISP A is charged a higher rate for traffic sent to R2. You are asked to lower costs for ISP A by configuring R1 to send traffic to R3 whenever possible.What are two ways to do this? (Choose two.)
which MPLS feature was used to make the LSP the preferred path for internal routes?
Click the Exhibit button.
Referring to the exhibit, which MPLS feature was used to make the LSP the preferred path for internal routes?
Which configuration sample on R3 and R5 will complete this task?
Click the Exhibit button.
In the exhibit, Area 1 is a not-so-stubby area. Three networks are redistributed into Area 1 on R2. You must summarize the redistributed network addresses in Area 1 so that only one network prefix is re-advertised into Area 0. You must also summarize the loopback addresses of R1 and R2 into a single address in Area 0.Which configuration sample on R3 and R5 will complete this task?
what is the shortest path to reach R3 from R1?
Click the Exhibit button.
Based on the SPF calculation in the exhibit, what is the shortest path to reach R3 from R1?
Which “Link type” should be displayed in the output?
Click the Exhibit button.
Sw-1, as configured in the exhibit, is directly connected to Sw-2 through ge-0/0/2.
The "Link type" field in show spanning-tree interface ge-0/0/2.0 detail vlan-id 20 output has been omitted from the exhibit.
Which "Link type" should be displayed in the output?
Which action resolves the Layer 2 loop while maintaining backup connectivity?
Click the Exhibit button.
In the exhibit, the enterprise is running RSTP on all switches in its network and is currently experiencing Layer 2 loops.
The primary link is between switch 1 and switch 2. For redundancy, a secondary Layer 2 link is purchased from the provider.
The provider uses Q-in-Q tunneling to transport the enterprise’s Layer 2 frames.
Which action resolves the Layer 2 loop while maintaining backup connectivity?
why is R2 marking the routes coming from AS 200 as hidden?
Click the Exhibit button.
Based on the exhibit, why is R2 marking the routes coming from AS 200 as hidden?
Which bridge is the root for CIST?
Click the Exhibit button.
Sw-1 and Sw-2 as shown in the exhibit are configured as follows:
Sw-1
admin@Sw-1# show
configuration-name juniper;
revision-level 1;
bridge-priority 4k;
msti 1 {
vlan 10;
}
msti 2 {
vlan 20;
}
Sw-2
configuration-name juniper;
revision-level 1;
bridge-priority 8k;
msti 1 {
vlan [ 10 15 ];
}
msti 2 {
vlan 20;
}
Which bridge is the root for CIST?
which two statements are true?
Click the Exhibit button.
Referring to the exhibit, which two statements are true? (Choose two.)