Click the Exhibit button.

Referring to the OSPF link metrics in the exhibit, which path will traffic from R6 take to reach R1?

Click the Exhibit button.

The exhibit shows the output of a Junos show bgp neighbor command.Which two statements are true? (Choose two.)

Click the Exhibit button.

You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across both available links to ISP B’s network. Which command do you use to finish the configuration?

Click the Exhibit button.

Referring to the exhibit, which type of traffic protection mechanism is used for the LSP?

Click the Exhibit button.

Customer A is complaining that CE1 and CE2 cannot form an OSPF adjacency across your LDP Layer 2 circuit. The physical topology of the network is CE1-PE1-P-PE2-CE2. PE1’s loopback is 192.168.5.1, P’s loopback is 192.168.6.1, and PE2’s loopback is 192.168.7.1Referring to the output in the exhibit, what is the problem?

Click the Exhibit button.

A LDP Layer 2 circuit is shown for VPN A and VPN B. LDP tunneling over RSVP is activated on P1 and P2. Referring to the exhibit, which statement is true about the LDP Layer 2 circuit?

Click the Exhibit button.

Based on the output in the exhibit, which statement is correct?

Click the Exhibit button.

You are configuring a new PE router in your Layer 3 VPN. A remote PE router is using the configuration shown in the exhibit.Which configuration is needed to receive customer-vpn routes from the remote PE?

Click the Exhibit button.

Referring to the exhibit, your network management systems have alerted you to a loss of connectivity to the CE2 router in your Layer 3 VPN. The loopback address of the CE router is 10.10.1.1/32.Which operational command on PE2 verifies connectivity across the PE-CE link?

Click the Exhibit button.

In the exhibit, Area 1 and Area 2 are configured as not-so-stubby areas. RIP network 192.168.100.0/24 is redistributed into OSPF in Area 1.Which three statements are true? (Choose three.)