Refer to the Exhibit.

In the exhibit, switches S1, S2, and S3 have Q-in-Q tunneling configured between Site 1 and Site 2.Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol (CDP), but blocks VLAN Trunking Protocol (VTP) between Site 1 and Site 2?

Your customer has five office locations. Each office location has 20 VLANs configured, one for each department. Your engineering team has recently secured a government contract with strict regulations which require that engineers be placed into separate workgroups. These workgroups cannot communicate with each other. Without changing the primary VLAN assignments, which JUNOS feature meets this requirement with minimal configuration?

Which two statements about MVRP on EX Series switches are true? (Choose two.)

Refer to the Exhibit.

Looking at the trace options output in the exhibit, why are the OSPF routers stuck in Init state?

Refer to the Exhibit.

As shown in the exhibit, the 10.10/16 prefix is redistributed into OSPF through R2 and R5. R2 and R5 are advertising the prefix with a Type 2 metric of 100.What is the preferred path to reach 10.10/16 from R6?

Which AS path regular expression will only match a route originating in AS 500 with the last traversing AS of 100?

Refer to the Exhibit.

In the exhibit, Source is sending multicast traffic to the multicast group address ffbe::1.Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?

How does an administrator block IGMP reports for the 239.0.0.0/8 group range?

You notice that a number of IGMP leave group messages are passing through a BMA network and are impacting the network’s performance. What would you do to resolve this issue without affecting multicast traffic?

R1 has an OSPF adjacency with R2 over a point-to-point link. Which three statements about the advertisements for this link in the Type 1 (Router) LSA generated by R1 are true? (Choose three.)