Which configuration is valid?
Refer to the Exhibit.
All routers shown in the exhibit are BGP neighbors. R1 must be a route reflector, and R2 through R5 must be clients. R2 should only receive one copy of all routes sent from R4.
Which configuration is valid?
What happens to traffic exceeding 100 Mbps?
Refer to the Exhibit.
You manage an MX series router (with 100 ms buffer size per port) that includes the configuration shown in the exhibit. Traffic marked with DSCP 000011 is entering the ge-1/0/4 interface at 102 Mbps. The traffic exits the device on the ge-1/0/5 interface. There is no other traffic transiting the router. What happens to traffic exceeding 100 Mbps?
Which statements are true about graceful Routing Engines switchover (GRES)?
Which statements are true about graceful Routing Engines switchover (GRES)?
Which configuration excerpt will advertise all local IPv4 and IPv6 destinations to the network?
Which configuration excerpt will advertise all local IPv4 and IPv6 destinations to the network?
Referring to the exhibit, which statement is true assuming LDP VPN signaling?
Refer to the Exhibit.
Referring to the exhibit, which statement is true assuming LDP VPN signaling?
Which approach can you use to implement IPv6-over-IPv4 tunneling?
Which approach can you use to implement IPv6-over-IPv4 tunneling?
Which choice shows the configuration in the exhibit in SLAX format?
Refer to the Exhibit.
Which choice shows the configuration in the exhibit in SLAX format?
What can be done to enforce this behavior?
Refer to the Exhibit.
R3 is announcing a route to R4 using EBGP, as shown in the exhibit. All routers in AS 65221 should learn this route, but it should not be announced to any other AS. What can be done to enforce this behavior?
Which operational command can verify load balancing?
Which operational command can verify load balancing?
Which policy action should router R3 configure to make this route visible on routers R1 and R2?
Refer to the Exhibit.
A route is advertised from AS 65221 to AS 65432 using EBGP. The route is active and reachable on R3, but does not appear as an active route on R1 and R2. R3 has an export policy applied to its IBGP group matching on routes from R4, but does not have a then criteria specified. Which policy action should router R3 configure to make this route visible on routers R1 and R2?