Refer to the Exhibit.

On Switch-1, all configured interfaces belong to the default VLAN. Based on the topology and bridge table shown in the exhibit, which two operations will Switch-1 perform if it receives a frame sent by User A with a destination MAC address of 00:26:88:02:74:89? (Choose two.)

You configure a metric of 200 on an IS-IS enabled interface on Router-1. When you examine the routing table entry for that link on another IS-IS device, you see a metric of 67.

What would explain this behavior?

Which two prerequisites does IS-IS need to operate? (Choose two.)

On a broadcast network, which three statements are true about IS-IS adjacencies? (Choose three.)

What does the attach bit in an IS-IS PDU indicate?

Which two events trigger an IS-IS LSP to be sent to a neighboring IS? (Choose two.)

You see a route in your local routing table that was learned using OSPF.
Which command allows you to determine where the route originated?

Refer to the Exhibit.

In the exhibit, you run the command show ospf neighbor on R3 and notice that an adjacency with R5 remains in the 2-Way state.
Which statement is true?

You must route both IPv4 and IPv6 packets in your environment.
Which configuration should you add at the [edit protocols] level to allow you to accomplish this objective?

You are viewing the output of the operational-mode command show interfaces ge-0/0/4 on an EX Series switch in which no ether-options are configured for the ge-0/0/4 interface.

Which two default settings are listed in the output? (Choose two.)