Refer to the Exhibit.

A router is configured with the configuration shown in the exhibit. Traffic arriving on fe-0/0/0.0 is not being routed to 10.1.1.1.
What can you change to make the device route traffic arriving on fe-0/0/0.0 to 10.1.1.1?

You have a route in the inet.0 routing table that has four valid physical next hops assigned to it.
Which event prompts an update to the information in the forwarding table for this particular route?

Which three attributes are considered in the default configuration of per-flow load balancing for routed IPv4 traffic? (Choose three.)

Router-A has an OSPF route to destination 172.18.3.0/24 with four equal-cost paths. How will Router-A forward traffic destined to 172.18.3.5 based on Junos OS’s default behavior?

You want to configure per-fpacket load balancing for all routes on Router-1.
Which configuration example accomplishes this?

You want to configure per-flow equal-cost multipath (ECMP) load balancing for only the OSPF routes on Router-1.
Which configuration example accomplishes this?

Which three types of firewall filters are supported on EX Series switches? (Choose three.)

Refer to the Exhibit.

You just applied the Layer 2 firewall filter shown in the exhibit to a port as an input filter to block traffic from a one source MAC address. After monitoring the port, you notice that all traffic ingressing that port has stopped flowing.
What is the problem?

What is the proper ingress processing sequence for firewall filters on an EX Series switch?

You want to alter the factory-default storm control configuration so that interfaces on which the storm control level is exceeded are temporarily shut down for five minutes. Which configuration excerpt accomplishes this objective?