Area 2 has been configured as a totally stubby area.Which three LSA types does Router B suppress from Area 2?
Router B is an OSPF router connected to both Area 0 and Area 2. Area 2 has been configured as a totally stubby area.Which three LSA types does Router B suppress from Area 2? (Choose four.)
What is the size of the unique address used to identify each node on an Ethernet LAN?
What is the size of the unique address used to identify each node on an Ethernet LAN?
Which two IS-IS packet types are used to maintain IS-IS database synchronization? (Choose two.)
Which two IS-IS packet types are used to maintain IS-IS database synchronization? (Choose two.)
What are three ways to configure IPv6 addresses in your network? (Choose three.)
What are three ways to configure IPv6 addresses in your network? (Choose three.)
Which two commands would be used to help identify the source of the problem? (Choose two.)
You notice that a route from internal BGP peer 192.168.1.1 is missing from the local route table.Which two commands would be used to help identify the source of the problem? (Choose two.)
Which two topologies shown in the exhibit could be implemented without a spanning-tree protocol? (Choose two.)
Refer to the Exhibit.
Which two topologies shown in the exhibit could be implemented without a spanning-tree protocol? (Choose two.)
In the exhibit, all routers are sending routes to Router B.Which routes will be advertised from Router B to Ro
Refer to the Exhibit.
In the exhibit, all routers are sending routes to Router B.Which routes will be advertised from Router B to Router E?
You have made no other configuration changes to the forwarding decisions made by the router.Which commands can
In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router.Which commands can you use to determine which LSP is being used to forward packets?
Which two values are used by an RSTP bridge to remove stale BPDU information? (Choose two.)
Which two values are used by an RSTP bridge to remove stale BPDU information? (Choose two.)
You issue the show spanning-tree mstp configuration command on both switches and notice that the configuration
You have recently configured MSTP on two switches in your network to participate in the same MSTP region. You issue the show spanning-tree mstp configuration command on both switches and notice that the configuration digests do not match.What does this mismatch indicate?