Refer to the Exhibit.

Based on the output in the exhibit, which statement is correct?

Refer to the Exhibit.

Customer A is complaining that routes advertised from the CE2 router are not being received on
the CE1 router. The physical topology of the network is CE1-PE1-PE2-CE2. The CE1-PE1 subnet
is 172.16.1.0/24. The CE2-PE2 subnet is 172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s
loopback is 192.168.4.1.Referring to the output in the exhibit, what is the problem?

Refer to the Exhibit.

In the exhibit, all routers within each AS are configured for Anycast RP. All intra-AS routers are
configured within the same MSDP mesh group. Inter-AS multicast has been enabled using MSDP
without MSDP mesh groups. Which statement is true?

What does the Junos command advertise-inactive allow?

Refer to the Exhibit.

The routers shown in the exhibit are connected in a full BGP mesh. R1 is the route reflector and
R2 through R5 are clients. R3 should only receive one copy of all routes sent from R4.Which
configuration is valid?

You manage an MPLS network. You are asked to classify traffic using the EXP bits from ingress to
egress. What will allow you to accomplish this?

Junos scripts can be written in which two languages? (Choose two.)

Refer to the Exhibit.

You are an employee of ISP A. You must not allow traffic between ISP B and ISP C to cross your
network, but customers of ISP B and ISP C must be able to reach your customers. Referring to the
exhibit, which two actions would do this? (Choose two.)

Refer to the Exhibit.

Customer A is complaining that CE1 and CE2 cannot form an OSPF adjacency across your LDP
Layer 2 circuit. The physical topology of the network is CE1-PE1-P-PE2-CE2. PE1’s loopback is
192.168.5.1, P’s loopback is 192.168.6.1, and PE2’s loopback is 192.168.7.1.
Referring to the output in the exhibit, what is the problem?

You are a network administrator in charge of configuring CoS for your network. Your network
includes a voice application with strict latency requirements, so that any packets delayed by more
than 75 ms are effectively useless. When configuring the scheduler for this application, which
feature ensures that you do not waste buffer space?