which statement is true about the LDP Layer 2 circuit?
Refer to the Exhibit.
A LDP Layer 2 circuit is shown for VPN A and VPN B. LDP tunneling over RSVP is activated on
P1 and P2. Referring to the exhibit, which statement is true about the LDP Layer 2 circuit?
what is the problem?
Refer to the Exhibit.
Customer A is complaining that CE1 and CE2 cannot form an OSPF adjacency across your LDP
Layer 2 circuit. The physical topology of the network is CE1-PE1-P-PE2-CE2. PE1’s loopback is
192.168.5.1, P’s loopback is 192.168.6.1, and PE2’s loopback is 192.168.7.1.
Referring to the output in the exhibit, what is the problem?
which type of traffic protection mechanism is used for the LSP?
Refer to the Exhibit.
Referring to the exhibit, which type of traffic protection mechanism is used for the LSP?
Which command do you use to finish the configuration?
Refer to the Exhibit.
You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across
both available links to ISP B’s network. Which command do you use to finish the configuration?
Which two statements are true?
Refer to the Exhibit.
The exhibit shows the output of a Junos show bgp neighbor command. Which two statements are
true? (Choose two.)
which path will traffic from R6 take to reach R1?
Refer to the Exhibit.
Referring to the OSPF link metrics in the exhibit, which path will traffic from R6 take to reach R1?
Which statement is true?
Refer to the Exhibit.
A customer is using the Layer 3 VPN multicast technology shown in the exhibit. Which statement
is true?
Which configuration is valid?
Refer to the Exhibit.
In the exhibit, R1 is a route reflector and R2 through R5 are clients in a full mesh configuration. R2
should only receive one copy of all routes sent from R5.Which configuration is valid? 
which routing table on RP1 are source-active messages (SAs) received from RP2 by default?
In an interdomain multicast deployment scenario, an RP1 is in AS1 and an RP2 is in AS2. MSDP
is configured between RP1 and RP2.In which routing table on RP1 are source-active messages
(SAs) received from RP2 by default?
which statement is true?
Refer to the Exhibit.
R3 and R4 want to establish an EBGP session between each other’s loopback addresses. They
have each configured static routes to the other’s loopback address and can ping from loopback to
loopback. Their EBGP session is configured with correct neighbor and local addresses. The
correct AS numbers have been specified at the [routing-options] hierarchy as well. Considering the
topology in the exhibit, which statement is true?