Which of the following may cause this?
The network administrator attempts to add interface G0/0/1 on Switch A to Eth-trunk 1, however the command
fails.
Which of the following may cause this?
which of the following is true?
The network administrator wishes to forward data over an Eth-trunk, however associated member interfaces
operate at different rates. In terms of the resulting behavior, which of the following is true?
which of the following?
In Layer 2 mode, the transmission rate of an Eth-Trunk interface is determined by which of the following?
which of the following parameters?
The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards frames
based on which of the following parameters?
What is the maximum number of member interfaces support…
What is the maximum number of member interfaces supported by a single Eth-Trunk?
What benefits does port aggregation yield?
What benefits does port aggregation yield? (Choose three)
which layer is port aggregation implemented?
In port aggregation, “multiple” ports are aggregated to form a port aggregation group so that all the member
ports in the group share the outgoing/incoming load.
At which layer is port aggregation implemented?
Which of the following represent advantages of link agg…
The network administrator has decided to configure link aggregation in the enterprise network.
Which of the following represent advantages of link aggregation? (Choose three)
which feature?
In a network supporting IPv6, OSPF no longer supports which feature?
Which of the following commands should be used to enabl…
In a small network supporting IPv6, a network administrator wishes implement RIPng.
Which of the following commands should be used to enable this protocol?