what will happen?
Two routers are connected via serial interfaces and the link-protocol is PPP, but the MRU of two serial
interfaces are different, in PPP LCP negotiated stage, what will happen?
which type of packet will be sent to the authenticated …
If PPP authentication fails, which type of packet will be sent to the authenticated peer by the authenticator?
Which PPP authentication method provides a more secure …
Two routers are connected via serial interfaces, for which the link-protocol is PPP. The network administrator
wishes to configure PPP authentication to improve security on this link.
Which PPP authentication method provides a more secure solution?
What are the three protocol components defined by PPP?
What are the three protocol components defined by PPP? (Choose three).
Which parameters must be negotiated to establish the PP…
Two routers are connected through serial interfaces and support PPP encapsulation.
Which parameters must be negotiated to establish the PPP connection? (Choose three).
What functions does a Hello packet of OSPF implement?
What functions does a Hello packet of OSPF implement? (Choose two)
What can be understood from this information?
After checking the OSPF neighbor state, the administrator discovers that the router has established a
TWOWAY state with the peering router.
What can be understood from this information? (Choose two)
By default, the Huawei router will select the route lea…
Assume that the router has learnt the best route to the same destination by using RIP, OSPF and Static Route
respectively. By default, the Huawei router will select the route learnt via ( ) as the best route.
Which route (s) will be found in the routing table?
A router has learned two routes for the same network with the same prefix. One route has been learned via
OSPF with a metric of 4882, while the other route has been learned via RIPv2 with a metric of 4.
Which route (s) will be found in the routing table?
which of the following represent the correct sequence f…
According to the default value of route preference on the VRP platform, which of the following represent the
correct sequence for direct route, static route, RIP and OSPF if they are listed from high preference to low
preference?