The network administrator needs to configure static NAT on RTA, in order to allow Host A to communicate with
Host C.
Which command is correct?

A web server in a private network is required to provide HTTP services to public users. The network
administrator is required to configure NAT on RTA.
Which configuration should be used?

NAPT allows for multiple internal addresses to be mapped to a single public address.
How does NAT distinguish between the different private addresses when mapping to the same public address?

A network requires a solution to allow 50 private IP addresses to be translated, however only a single public
address is available for use.
Which translation method can be used to support this requirement?

The network administrator attempts to add interface G0/0/1 on Switch A to Eth-trunk 1, however the command
fails.
Which of the following may cause this?

The network administrator wishes to forward data over an Eth-trunk, however associated member interfaces
operate at different rates. In terms of the resulting behavior, which of the following is true?

In Layer 2 mode, the transmission rate of an Eth-Trunk interface is determined by which of the following?

The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards frames
based on which of the following parameters?

What is the maximum number of member interfaces supported by a single Eth-Trunk?

What benefits does port aggregation yield? (Choose three)