Which inline commands do you issue to check if there is any I/O on SA/FA Host Adaptors?
A customer wants you to assist them in shutting down a DMX1000. Which inline commands do
you issue to check if there is any I/O on SA/FA Host Adaptors?
What is a major difference in director data flow between the Symmetrix 8000 series and a DMX-2?
What is a major difference in director data flow between the Symmetrix 8000 series and a DMX-2?
What does this tell you about the configuration of this Fibre Channel?
While investigating an FA Fibre Channel problem, you issue an 8F,,,0 command. You notice that
the Loop ID value is “None”. What does this tell you about the configuration of this Fibre Channel?
which SIM codes should be disabled?
Your customer has requested that you disable the SIMs before you replace a disk. The customer
makes this request because the last time a disk was replaced, the customer’s console was flooded
with error messages. When you run the E7,CF,’SIMM’ inline command, which SIM codes should
be disabled?
which section of 5671 SymmWin’s Procedure Wizard would you find the script to accomplish this?
You want to disable SIMM messages to the customer’s console. You log in as a CE. In which
section of 5671 SymmWin’s Procedure Wizard would you find the script to accomplish this?
Which operation is displayed?
Refer to the exhibit. 
Which operation is displayed?
Which operation is shown?
Refer to the exhibit. 
Which operation is shown?
What is the maximum number of DAEs and drives supported by a DMX950?
What is the maximum number of DAEs and drives supported by a DMX950?
What does the yellow 6 on Symm Dev 169 indicate?
Refer to the Exhibit. 
What does the yellow 6 on Symm Dev 169 indicate?
which slot will you find FEBE0 board in a Symmetrix DMX-800 System?
Refer to the Exhibit. 
In which slot will you find FEBE0 board in a Symmetrix DMX-800 System?