Which Open Replicator Hot Pull feature allows them to minimize the possibility of data loss during the migrati
A customer is planning a technology refresh. The proposed migration will make use of Open
Replicator Hot Pull. Which Open Replicator Hot Pull feature allows them to minimize the
possibility of data loss during the migration?
Which parameter should be changed?
Refer to the exhibit.
A customer has a Symmetrix VMAX storage array configured with FAST VP using three
storage tiers. Policies are active for all storage groups on the array. The array has been in
service for over 30 days. When using Unisphere for VMAX to check, the customer notices no
active ingress and egress of extents for the EFD tier. The current configuration of FAST is
shown in the exhibit. Which parameter should be changed?
Which parameter should be changed?
Refer to the exhibit.
A customer has a Symmetrix VMAX storage array configured with FAST VP using three
storage tiers. Policies are active for all storage groups on the array. The customer would like
to increase the size of data movement requests. The current configuration of FAST is shown
in the exhibit. Which parameter should be changed?
Which policy applied to the workload provides the best response time for the minimum expenditure?
Refer to the exhibit.
You are considering potential configurations of a new storage system. You need to make
decisions that consider different cost-benefit ratios. Which policy applied to the workload
provides the best response time for the minimum expenditure?
Which policy applied to the workload provides the minimum expenditure?
Refer to the exhibit.
You are considering potential configurations of a new storage system. You need to make
decisions that consider different cost-benefit ratios. Which policy applied to the workload
provides the minimum expenditure?
how should the pool be built?
A customer has a Symmetrix VMAX storage array configured with 94.9% utilization of raw
storage capacity, according to symwin. The frame is configured as shown in the exhibit. The
SRDF/A replication suspends regularly. Investigation shows write pending values are too
high for the R1 volumes. I/O requirements for the DSE pool are computed.
If DSE is used, where and how should the pool be built?
how should the pool be built?
A customer has a Symmetrix VMAX storage array configured with 99.9% utilization of raw
storage capacity. The frame is configured with storage pools as shown in the exhibit. Note
the following:
Pool P00400GE00R5 is 400 GB SSD RAID 5
Pool P02002TS72R6 is 2000 GB SATA RAID 6
Pool P01450GF15R1 is 450 GB FC 2-Way-Mir
SRDF/A replication suspends regularly
Investigation shows that write pending values are too high for the R1 volumes. I/O
requirements for the DSE pool are computed. If DSE is used, where and how should the
pool be built?
What should be your recommendation?
Exhibit:
You have used BCSD to model an SRDF/A solution and have an SRDF/A risk analysis, as
shown in the exhibit. What should be your recommendation?
What is the recommended best practice when zoning an ESXi host with two HBAs to the VMAX?
Refer to the exhibit.
A company plans to deploy a one-engine Symmetrix VMAX array in their VMware vSphere
environment. The ESXi hosts will be connected to the VMAX array over a FC SAN. What is
the recommended best practice when zoning an ESXi host with two HBAs to the VMAX?
What is the recommended best practice when zoning an ESXi host with two HBAs to the VMAX?
Refer to the exhibit.
A company plans to deploy a two-engine Symmetrix VMAX array in their VMware vSphere
environment. The ESXi hosts will be connected to the VMAX array over a FC SAN. What is
the recommended best practice when zoning an ESXi host with two HBAs to the VMAX?