What can be done to accommodate these interfaces on three separate subnets?
Three different IP interfaces have been defined for a single port on a Data Mover.
What can be done to accommodate these interfaces on three separate subnets?
What additional option is used to add statistical load distribution to the trunk configuration?
An administrator needs to configure a network trunk on a Data Mover using the command:
server_sysconfig server_2 -virtual -name trk0_la -create trk -option “device=cge2,cge3 protocol=lacp
What additional option is used to add statistical load distribution to the trunk configuration?
What is one possible cause for this?
One of the Celerras in the data center dropped all client access suddenly. Upon further
investigation, you discover that the primary blade is in a panicked state but did not fail over to the standby blade.
What is one possible cause for this?
What networking configuration issue could be causing this problem?
You have performed a Data Mover failover test, and now CIFS shares and NFS exports are
unavailable. You cannot ping or tracert to their assigned IP interfaces.
What networking configuration issue could be causing this problem?
If a primary Data Mover becomes unavailable, the standby uses what two addresses of the new primary Data Mover
If a primary Data Mover becomes unavailable, the standby uses what two addresses of the new primary Data Mover?
What is the number of standby Data Movers required to achieve high availability in a Celerra model using eight
What is the number of standby Data Movers required to achieve high availability in a Celerra model using eight Data Movers?
Which pool and disk configuration would be configured for the best archival performance while maintaining low
You are implementing a Celerra unified storage system in a data archive solution. An additional
DAE with SATA disks has been added to the system and you are to configure the disks to create a Celerra storage pool.
Which pool and disk configuration would be configured for the best archival performance while maintaining low cost?
What are the possible disk configurations/Celerra storage pools that can be made using these disks?
You are implementing a Celerra gateway system into an existing CLARiiON back end with 11 available EFDs.
What are the possible disk configurations/Celerra storage pools that can be made using these disks?
Which Data Mover component is designed to improve response time for user mapping requests?
Which Data Mover component is designed to improve response time for user mapping requests?
What will be resulting root file system name?
A storage administrator created a new Virtual Data Mover with the name “vdm01” using the
following command:
$ nas_server name vdm01 type vdm create server_2 setstate loaded
What will be resulting root file system name?