Which command is used to gather information from the Storage Processors?
You are troubleshooting a CLARiiON Array running Release 19. Which command is used to gather information from the Storage Processors?
Why is the r flag used in a setsniffer command?
Why is the r flag used in a setsniffer command?
Which software component in a CLARiiON Array do Navisphere CLI commands communicate with?
Which software component in a CLARiiON Array do Navisphere CLI commands communicate with?
What is the correct disk-position designation for disk Bus 0 Enc 1 dsk 2 when running the navicli getdisk comm
What is the correct disk-position designation for disk Bus 0 Enc 1 dsk 2 when running the navicli getdisk command?
How do you locate the WWPN for all the ports of SPA on a CS Series Array from the Navisphere GUI?
How do you locate the WWPN for all the ports of SPA on a CS Series Array from the Navisphere GUI?
Match the Utility Partitions to the attached diagram.
What might be the cause?
A battery test is performed. Only one SPS is present in the Array. Your customer notes that performance was impacted. What might be the cause?
Which interface is recommended?
You are using the host-based FBI to monitor a CX-Series Array. Which interface is recommended?
What information is required in the CAP2 Capture-Wizard before host data is collected?
What information is required in the CAP2 Capture-Wizard before host data is collected?
Which method is available as a connect home option?
Which method is available as a connect home option?