What best explains the data presented in this exhibit?
what data chart identifies the overall RF utilization o…
In a PC-based spectrum analyzer, what data chart identifies the overall RF utilization of a specific frequency
in the environment being surveyed?
What is the meaning of the chart shown in the exhibit a…
What is true about this RF environment and its potentia…
A wireless engineer from your company performed a site survey in an office building where a wireless
network extension was needed. He reports that while performing a Layer 1 sweep near a meeting room full
of people, he detected the RF environment displayed in the exhibit. He is unsure how to interpret what he
recorded to determine its impact on a future Wi-Fi network.
What is true about this RF environment and its potential impact on the WLAN?
What is the purpose of this feature and when would you …
While configuring your site survey software for an upcoming manual survey project, you notice the
configuration option for “Network Card Simu-lation” as shown in the exhibit.
What is the purpose of this feature and when would you use it?
what calibration method will lead to the most accurate …
When preparing a floor plan graphic for use in predictive and manual site surveying, what calibration
method will lead to the most accurate and reliable RF data?
What exhibit reflects the recommended life-cycle steps …
what is a best practice for configuration of the simula…
When performing an indoor predictive site survey to make the WLAN planning and design cycle more
efficient, what is a best practice for configuration of the simulated APs in the predictive modeling software?
What potential drawback is present with this DFS test m…
You are on site, planning a network at a freight shipping company on a busy harbor. Since the preliminary
WLAN design specifies support for the 5 GHz spectrum, you would like to test for radar pulses to determine
if DFS channels should be supported at this facility. As a part of your spectral survey with a laptop-based
analyzer, you include DFS testing to identify the presence of radar. This is done by manually observing
Real-time FFT, Duty Cycle, and Active Devices charts of the spectrum analyzer software.
What potential drawback is present with this DFS test method? (Choose 3)