You boot a Cisco TelePresence System TX1300. A red X appears during step 6 in the boot process.
Which of the following should you do?
A.
Reboot the system.
B.
Configure a static IP address.
C.
Contact Cisco Technical Support.
D.
Check the status of the DHCP server.
E.
Check the network port and the Ethernet cable.
Explanation:
You should contact Cisco Technical Support. If a red X appears on the screen during step 6 in the boot process
of a Cisco TelePresence System (CTS) TX1300, the device has experienced a compact flash error, which
requires that you contact Cisco Technical Support.
You need not check the network port and the Ethernet cable. If a red X appears on the screen during step 4 inthe boot process for a CTS TX1300, you should check the network port and the Ethernet cable. The fourth step
verifies whether the CTS TX1300 has network connectivity. If the CTS TX1300 has network connectivity, the
fourth circle in the lower left-hand corner will contain a check mark; if not, it will contain a red X.
You need not check the status of the Dynamic Host Configuration Protocol (DHCP) server. If the CTS TX1300
cannot reach a DHCP server, it will configure itself with the IP address 192.168.100.2. A red X will not be
displayed if the CTX TX1300 has network connectivity but cannot reach the DHCP server.
You need not reboot the CTS TX1300. Rebooting the system is unlikely to fix a compact flash error.
You need not configure a static IP address. Configuring a static IP address will not fix a compact flash error.Cisco: First-Time Setup: Loading your Software and Initial System Configuration