PrepAway - Latest Free Exam Questions & Answers

Which of the following are true regarding the debug output shown in the graphic?

Which of the following are true regarding the debug output shown in the graphic?(choose two)

PrepAway - Latest Free Exam Questions & Answers

A.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#version 2
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0

B.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0

C.
Network 10.0.0.0 will be displayed in the routing table.

D.
Network 192.168.168.0 will be displayed in the routing table.

E.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 192.168.1.0
RtrA(config-router)#network 10.0.0.0
RtrA(config-router)#network 192.168.168.0

F.
split-horizon was disabled on this router.

Explanation:

Routing Information Protocol (rip) is a distance vector protocol that uses hop as a metric. Rip routing metric: rip uses single routing metric (hops) to measure the distance from source network to destination network. From source to destination, every hop is given a value, which is usually 1. When routers receive route update information of new or changed destination network, the metric value will be added 1 and then stored into a routing table, the ip address of the sender will be used as the next hop address.


Leave a Reply