Cisco Exam Questions

Which is the correct command set to configure LACP on Switch2?

Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct
command set to configure LACP on Switch2?

A.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode desirable

B.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode on

C.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode auto

D.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode passive