You are troubleshooting a Cisco AnyConnect VPN on a firewall and issue the command “show
webvpn anyconnect.” The output shows the message “SSL VPN is not enabled” instead of
showing the AnyConnect package. Which action can you take to resolve the problem?

A.
Issue the enable outside command.

B.
Issue the anyconnect enable command.

C.
Issue the enable inside command.

D.
Reinstall the AnyConnect image.

Explanation:
Configuring the ASA to Web-Deploy the Client
The section describes the steps to configure the ASA to web-deploy the AnyConnect client.
Detailed Steps
Command
Purpose
Step 1
anyconnect image filename order

Example:
hostname(config-webvpn)#anyconnect image
anyconnect-win-2.3.0254-k9.pkg 1
hostname(config-webvpn)#anyconnect image
anyconnect-macosx-i386-2.3.0254-k9.pkg 2
hostname(config-webvpn)#anyconnect image
anyconnect-linux-2.3.0254-k9.pkg 3
Identifies a file on flash as an AnyConnect client package file.
The ASA expands the file in cache memory for downloading to remote PCs. If you have multiple
clients, assign an order to the client images with the order argument.
The ASA downloads portions of each client in the order you specify until it matches the operating
system of the remote PC. Therefore, assign the lowest number to the image used by the most
commonly-encountered operating system.
Note
You must issue the anyconnect enable command after configuring the AnyConnect images with
the anyconnect image xyz command. If you do not enable the anyconnect enable command,
AnyConnect will not operate as expected, and show webvpn anyconnect considers the SSL VPN
client as not enabled rather than listing the installed AnyConnect packages.
Step 2
enable interface
Example:
hostname(config)# webvpn
hostname(config-webvpn)# enable outside
Enables SSL on an interface for clientless or AnyConnect SSL connections.
Step 3
anyconnect enable
Without issuing this command, AnyConnect does not function as expected, and a show
webvpn anyconnect command returns that the “SSL VPN is not enabled,” instead of listing
the installed AnyConnect packages.
Reference:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/vp
n_anyconnect.html