You issue the set upgrade display command.
When will the display peripheral be updated?
A.
immediately
B.
the next time the system restarts
C.
only after the upgrade display command is issued
D.
only after the show upgrade detail command is issued
E.
only after the utils upgrade peripherals command is issued
Explanation:
The display peripheral will be updated the next time the system restarts. The set upgrade display command
configures the display peripheral for a forced upgrade but does not immediately upgrade the peripheral. All
forced upgrades occur when the system restarts. You can issue the unset upgrade display command to clear a
forced upgrade of the display.
The utils upgrade peripherals command can initiate an immediate peripheral upgrade without restarting the
system. However, the utils upgrade peripherals command is not the only method that can be used to cause a
forced upgrade to occur. The optional nowarn keyword can be used to start the upgrade without notifying the
user.
Issuing the show upgrade detail command will not cause the display peripheral to update. The show upgrade
detail command will display the upgrade status, the current version, and the image version for each peripheral.
If a peripheral has been configured for a forced upgrade, the entry for the peripheral will be followed by an F.
The upgrade display command is an invalid command. To update the display, the next time the system restarts,
you should issue the set upgrade display command.Cisco: Command-Line Interface Reference Guide for Cisco TelePresence Immersive Systems: Set
Commands: set upgrade display