Refer to the exhibit.

Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet
0/10 is not the root port for VLAN 2?

A.
This switch has more than one interface connected to the root network segment in VLAN 2.

B.
This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.

C.
This switch interface has a higher path cost to the root bridge than another in the topology.

D.
This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

Explanation:
These four parameters are examined in order to make root bridge , root port , designated port.
Other switch has lowest Sending Bridge ID or Sending Port ID so vlan 2 is not the root port.
1. A lower Root Bridge ID2. A lower path cost to the Root3. A lower Sending Bridge ID4. A lower
Sending Port ID