Which two of these changes are necessary for SwitchA to meet the requirements?
Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.
Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)
What is valid reason for a switch to deny port access to new devices when port security is enabled?
What is valid reason for a switch to deny port access to new devices when port security is enabled?
Which commands will accomplish this?
Refer to the graphic. A static route to the 10.5.6.0/24 network is to be configured on the HFD router. Which commands will accomplish this? (Choose two.)
Which two statements are correct regarding the router hardware?
Refer to the partial command output shown. Which two statements are correct regarding the router hardware? (Choose two.)
Which two tasks does the Dynamic Host Configuration Protocol perform?
Which two tasks does the Dynamic Host Configuration Protocol perform? (Choose two.)
Which three options are valid WAN connectivity methods?
Which three options are valid WAN connectivity methods? (Choose three.)