Which controller CLI command assigns its management interface to the Cisco IOS Catalyst switch native vlan int
A controller is connected to a Cisco IOS Catalyst switch. The following is the switch port
configuration:
interface GigabitEthernet 1/0/10
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,20,30,50
switchport trunk native vlan 20
switchport mode trunk
Which controller CLI command assigns its management interface to the Cisco IOS Catalyst switch
native vlan interface?
Which type of cable is used to connect the COM port of a host to the COM port of a router or switch?
Which type of cable is used to connect the COM port of a host to the COM port of a router or switch?
What is the name of the VTP mode of operation that enables a switch to forward only VTP advertisements while s
What is the name of the VTP mode of operation that enables a switch to forward only VTP advertisements while still permitting the editing of local VLAN information?
Which two benefits are provided by creating VLANs?
Which two benefits are provided by creating VLANs? (Choose two.)
Which two link protocols are used to carry multiple VLANs over a single link?
Which two link protocols are used to carry multiple VLANs over a single link? (Choose two.)
Which VTP mode is capable of creating only local VLANs and does not synchronize with other switches in the VTP
Which VTP mode is capable of creating only local VLANs and does not synchronize with other switches in the VTP domain?
What is the effect of adding switch ports to a new VLAN on the switch?
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?
Which two statements about the use of VLANs to segment a network are true?
Which two statements about the use of VLANs to segment a network are true? (Choose two.)
What will happen in this scenario?
Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An 802. 1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified.
What will happen in this scenario?
When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test?
When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test?