Refer to the partial Cisco IOS XR configurations exhibit for Router 1 and Router 2.

There are two routers that are connected back to back over the Gigabit Ethernet link. If the “show
mpls ldp neighbor” command output on Router 1 does not show LDP peering with Router 2, what
could be the possible root cause of the LDP peering problem?

Which Cisco IOS XR command should be used to identify if MPLS TE FRR is enabled?

When a link flaps, an mpls ldp session will also flap. Which feature minimizes traffic loss and
provides faster convergence after the link is re-established?

A DSCP value of 41 in decimal corresponds to which IP precedence value?

DRAG DROP
Drag each of the QOS mechanisms on the left to match the correct description on the right.

DRAG DROP
Drag the Cisco MQC configuration task on the left to match the correct description on the right.

DRAG DROP
Put the Mpls LDP steps on the left into the correct order from top to bottom on the right.

DRAG DROP
Drag the QOS model on the left to match its correct description on the right.

DRAG DROP
Drag the MPLS Diff-Serv Tunneling mode on the left to match the correct description on the right.

Scenario:

On the PE8-router what is the label value used to reach the 10.7.1.1/32 network prefix?