What is the maximum number of hexadecimal characters allowed when configuring the WPA or WPA2 passphrase in Ci
What is the maximum number of hexadecimal characters allowed when configuring the WPA or WPA2 passphrase in Cisco ADU?
Which problem may have caused this failure?
In a deployment using standalone access points, clients set up to authenticate with EAP-PEAP or EAP-Cisco Wireless (Cisco-LEAP) cannot authenticate. When you inspect the Failed Attempts report on the Cisco Secure ACS, you find this error: “Unknown network access server NAS.” Which problem may have caused this failure?
which two IETF RADIUS attributes should you configure on the Cisco Secure ACS?
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. In order to accomplish this, which two IETF RADIUS attributes should you configure on the Cisco Secure ACS? (Choose two.)
Which of the following would cause this failure?
Using the WLSE, you are trying to push out a configuration job to a standalone access point, but the job does not start. Which of the following would cause this failure?
What level do you set the bandwidth to?
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phone to drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kind of issue it is, you decide to increase the bandwidth reserved for roaming on the WLAN controller to the maximum. What level do you set the bandwidth to?
Which of these entities initializes the secure tunnel?
EAP-FAST provides a secure tunnel during Phase One to protect the user’s authentication credentials. Which of these entities initializes the secure tunnel?
which of the following actions should you perform on the wired infrastructure?
You are charged with implementing a secure wireless installation which will provide Internet access to client devices but will not allow communications between wireless clients. In addition to implementing PSPF or peer-to-peer blocking on the wireless side, which of the following actions should you perform on the wired infrastructure?
which two general control settings should you select?
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones, which two general control settings should you select? (Choose two.)
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticate the client when
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticate the client when one-time passwords are in use?
What is the correct order of steps for upgrading a Cisco WCS?
What is the correct order of steps for upgrading a Cisco WCS?