why 10.1.4.0/24 is not in PG-R1’s routing table?
Look at the following exhibit carefully, there is no route to 10.1.4.0/24 in the local routing table. According to the output of PG-R1 in the exhibit, can you tell me why 10.1.4.0/24 is not in PG-R1’s routing table?
which router will have originated it?
Based on the network provided in the exhibit, in these two areas, all routers are performing OSPF on all interfaces. After examining the OSPF database on PG-R4, do you know which type of LSA will contain 10.1.5.0/24, and which router will have originated it?
What LSAs will PG-R6 have in its local database for 10.1.5.0/24?
On the basis of the network provided in the exhibit, PG-R1 is injecting 10.1.5.0/24 by use of a network statement as a network (type 2) LSA. What LSAs will PG-R6 have in its local database for 10.1.5.0/24?
What is an important consideration that should be taken into account when configuring shaped round robin?
What is an important consideration that should be taken into account when configuring shaped round robin? (Exhibit)
which two tasks need to be performed prior to issuing the autoqos voip command in this router?
Refer to the exhibit. A network engineer received a sudden request to prioritize voice over his Cisco network and he has decided to leverage the AutoQoS feature. Based on the output shown, which two tasks need to be performed prior to issuing the autoqos voip command in this router? (Choose two.)
what type of marker is achieved?
Refer to the exhibit. Based on this configuration, what type of marker is achieved?
which four of these statements are true?
Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true? (Choose four.)
What would be two suggestions to load-balance the traffic across both WAN links?
Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links? (Choose two.)
what could be the most likely cause of the problem?
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?
Which mechanism can you use to achieve sub-second failover for link failure
Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?