A network engineer wants to automate the monitoring of Cisco TelePresence TX systems.
Which step should the engineer take first?

Management wants to modify Cisco TMS to allow users to configure the call behavior with
their associated devices and dial from a single ID.
Which feature needs to be enabled and configured?

Refer to the exhibit. Which tab can be used in order to check the call statistics for the Cisco
TelePresence Codec C60?

Which three features are supported by Cisco TMSPE? (Choose three.)

Refer to the exhibit. Which configuration element can be used to specify the Multiway address
that can be used by the endpoint to initiate Multiway calls?

Which two of these support an ad-hoc conference call? (Choose two.)

An important Cisco TelePresence video multipoint call is in progress and you are getting
complaints of pixilation of the video and poor audio quality on one of the involved systems.
Which page would be a good place to start for troubleshooting the issue on the affected
endpoint?

Which four features are provided by Cisco TelePresence Management Suite? (Choose four.)

Which Cisco TelePresence Multipoint Control Unit Layout view mode gives prominence to
one conference participant over the other conference participants while still allowing
conference participants to view multiple participants at the same time?

Which two layout or switching modes are supported with the Cisco TelePresence Multipoint
Switch? (Choose two.)