Refer to the exhibit.

Assume that NANP is being used and 9 is used for PSTN access code Long distance national calls are preceded with 1.
How should the HQ Cisco Unified Communications Manager be configured for calls to 3XXX to be sent to the gatekeeper at 10.1.6.1 with PSTN backups?

Refer to the exhibit.

The HQ site uses area code 650. The BR1 site uses area code 408. The long distance national code for PSTN dialing is 1. To make a long distance national call, an HQ or BR1 user dials access code 9, followed by 1, and then the 10-digit number. Both sites use MGCP gateways.
AAR must use globalized call routing using a single route pattern. Assume that all outgoing PSTN numbers are localized at the egress gateway as shown in the exhibit. What should the AAR group prefix be?

Refer to the exhibit.

Which statement about the configuration between the Default and BK regions is true?

Refer to the exhibit.

When the user of a phone registered to the Cisco Unified Communications Manager places a call to 3001 when the SAF network is down, what happens?

Refer to the exhibit.

Which pattern will be advertised try the Cisco Unified Communications Manager?

Refer to the exhibit.

Multicast MOH needs to be run from flash at the remote site. Which Cisco IOS configuration at the SRST router is correct?

Refer to the exhibit.

The H.323 Gateway is showing status "unknown". Which statement is true?

Which Cisco IOS command is used to verify that a SAF Forwarder that is registered with Cisco Unified Communications Manager has established neighbor relations with an adjacent SAF Forwarder?

Refer to the following exhibits.

Users in the U.S dial Germany by calling 9011 49 followed by the remaining digits. What would be the most suitable configuration for Connection X?

When an incoming PSTN call arrives at an MGCP gateway, how does the calling number get normalized to a global E.164 number with the + prefix in Cisco Unified Communications Manager?