Which two additions to the router B1 configuration should the engineer make?
Refer to the exhibit. A new TAC engineer comes to you for advice. The engineer wants to configure RIPv2-OSPF two-way redistribution while avoiding routing loops.
Which two additions to the router B1 configuration should the engineer make? (Choose two.)
Select 2 response(s).
which eBGP configurations would you configure in AS100 to influence AS200 to use the eBGP links more evenly?
Refer to the exhibit. Currently the two eBGP links between AS100 and AS200 have an average inbound load of 65% and 20% respectively. After further investigation, traffic to 10.10.1.16/28 accounts for 45%, and traffic to 10.10.1.32/28 and to 10.10.1.48/28 each account for 20% of the inbound load. The BGP attributes are currently set at their default values in both autonomous systems.
If you want to influence how AS200 sends traffic to AS100, which eBGP configurations would you configure in AS100 to influence AS200 to use the eBGP links more evenly? (Choose two.)
Select 2 response(s).
What did the TAC engineer configure incorrectly?
Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
Select the best response.
Which routes would be redistributed into OSPF area 1?
Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?
Select the best response.
which command should be added, or edited, on router B1 under router ospf 10?
Refer to the exhibit. The network administrator is trying to configure mutual redistribution between EIGRP and OSPF. Autosummarization in EIGRP 100 AS is disabled. After adding OSPF configuration to router B1, the network administrator checked the routing table of router B2, but none of the EIGRP routes appeared there.
To redistribute the EIGRP AS 100 routes into OSPF, which command should be added, or edited, on router B1 under router ospf 10?
Select the best response.
Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP?
Refer to the exhibit. Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP? (Choose three.)
Select 3 response(s).
what is one reason why no routes from the OSPF neighbor 192.168.0.5 are installed in the IP routing table?
Refer to the exhibit. Based on the command output, what is one reason why no routes from the OSPF neighbor 192.168.0.5 are installed in the IP routing table?
Select the best response.
Which statement about these configurations is true?
Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable.
Which statement about these configurations is true?
Select the best response.
Which ACL statement completes the configuration correctly?
Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default-network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly?
Select the best response.
Which would be the first logical step to take?
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routing match counts are not increasing.
Which would be the first logical step to take?
Select the best response.