What will the debug output on the console show?
The following commands are issued on a Cisco Router:
Router(configuration)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1
Router(configuration)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1
Router(configuration)#exit
Router#debug ip packet 199
What will the debug output on the console show?
What level of logging is enabled on a Router where the following logs are seen?
What level of logging is enabled on a Router where the following logs are seen?
%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
Which two commands will you use to replace the existing commands?
You have the followings commands on your Cisco Router:
ip ftp username admin
ip ftp password backup
You have been asked to switch from FTP to HTTP. Which two commands will you use to
replace the existing commands?
Which commands will you use to configure the router?
You have 2 NTP servers in your network – 10.1.1.1 and 10.1.1.2. You want to configure a
Cisco router to use 10.1.1.2 as its NTP server before falling back to 10.1.1.1. Which
commands will you use to configure the router?
Which two of the following options are categories of Network Maintenance tasks?
Which two of the following options are categories of Network Maintenance tasks?
Which layer of the OSI model does the problem most likely exist?
You enabled CDP on two Cisco Routers which are connected to each other. The Line and
Protocol status for the interfaces on both routers show as UP but the routers do not see
each other a CDP neighbors. Which layer of the OSI model does the problem most likely
exist?
which of the following ?
FCAPS is a network maintenance model defined by ISO. It stands for which of the following
?
Which three management categories are contained in the FCAPS network maintenance model?
Which three management categories are contained in the FCAPS network maintenance model?
(Choose three.)
What is the result of configuring the logging console warning command?
What is the result of configuring the logging console warning command?
What statement is correct regarding the output shown in the graphic?
Refer to the shown below.
%PIX|ASA-3-105010: (Primary) Failover message block alloc failed
• %PIX|ASA-3-106010: Deny inbound protocol src interface_name:dest_address/dest_port dst
interface_name:source_address/source_port
• %PIX|ASA-3-106011: Deny inbound (No xlate) string
• %PIX|ASA-3-106014: Deny inbound icmp src interface_name: IP_address dst interface_name:
IP_address (type dec, code dec)
• %PIX-3-107003: RIP: Attempted reference of stale data encountered in function, line: line_num
• %PIX|ASA-3-109010: Auth from inside_address/inside_port to outside_address/outside_port
failed (too many pending auths) on interface interface_name.
• %PIX|ASA-3-109013: User must authenticate before using this service
• %PIX|ASA-3-109016: Can’t find authorization ACL acl_ID for user ‘user’
• %PIX|ASA-3-109018: Downloaded ACL acl_ID is empty
• %PIX|ASA-3-109019: Downloaded ACL acl_ID has parsing error; ACE string
• %PIX|ASA-3-109020: Downloaded ACL has config error; ACE
• %PIX|ASA-3-109023: User from source_address/source_port to dest_address/dest_port on
interface outside_interface must authenticate before using this service.
What statement is correct regarding the output shown in the graphic?