What two tools can an engineer use to verify RF data rates and coverage after installation?
What two tools can an engineer use to verify RF data rates and coverage after installation?
(Choose two.)
What may prevent some clients from connecting?
During RF verification, some 5 GHz clients are unable to connect to certain APs, while other 5
GHz clients can connect to all APs. What may prevent some clients from connecting?
What redundancy model does this describe?
An engineer has WLC redundancy included in WLAN design documentation, where the WLCs are
loaded to half the license capacity therefore allowing half the WLCs to fail without an AP going
offline at a given time. What redundancy model does this describe?
what two locations should a linear point collection be performed?
An engineer is performing a data collection to validate wireless coverage. At what two locations
should a linear point collection be performed? (Choose two.)
What two menus will an engineer navigate to in order to determine the maximum number of supported APs?
An engineer is surveying a customer site for additional wireless coverage. What two menus will an
engineer navigate to in order to determine the maximum number of supported APs? (Choose two.)
What is the most AP licenses that can be supported?
An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP
licenses that can be supported?
What are the four major factors that should be considered?
An engineer is deploying an outdoor Mesh network. What are the four major factors that should be
considered? (Choose four.)
What supported switchport protocol or standard could be the reason for this?
An engineer installed a 1252 AP and is getting power from the switch. However, devices
connected to the wireless network cannot get 802.11n data rates. What supported switchport
protocol or standard could be the reason for this?
What Cisco access point should be recommended?
An engineer is performing a site survey for a 5 GHz mesh wireless network. The customer
requires 300 Mbps data rates per radio, 2×3 MIMO technology, and legacy beamforming. What
Cisco access point should be recommended?
What does this indicate?
While performing an active mesh survey with a Cisco 1550 Access Point, the status LED turns
solid red. What does this indicate?