What is the result of a Cisco 1250 AP deployed for 802.11a/b/g/n using optimized power (16.8 W)
with software version 7.0?

Customer requirements and a WLAN site survey require a Cisco 1250 AP operating at full
802.11a/b/g/n located approximately 150 meters from the closest IDF. What is the best solution to
provide wireless coverage to this portion of the customer’s facility?

You have completed a site survey for a customer that refurbishes/remanufactures automobile
engines. The site survey has determined that there are approximately 70 clients in the facility, but
because of the large number of engines as many as 2500 RFID tags will need to be tracked
through location services to provide historical location information and audit trails. The results of
the site survey require 60 APs for data and location services. How many version 7.0 controller(s)
will provide the most cost effective solution?

You have a customer that is building a new campus of four 3-story buildings that you have just
completed the site survey for. The customer is interested in the amount of rack space they will
need to allocate in either the building MDF or in the data center for controllers. Each building is
going to require 75 APs to support voice and data. How should the controllers be deployed to
provide the least number of controllers, the highest redundancy, and the easiest management?

Which two options indicate the RF channels regulated by 802.1h for outdoor deployment regarding
FCC? (Choose two.)

How would clients react to a controller configuration that utilized unsupported channels?

For better compatibility with 802.11n clients, which 802.11a channels should be utilized?

Which two of the following are considered best practices upon the completion of a wireless
installation? (Choose two.)

When using WCS 7.0 to calibrate a floor in a facility, which two factors are common to the point
and linear calibration methods? (Choose two.)

After you have run the VoWLAN Voice Readiness Tool in WCS 7.0, you see there are potential
problem areas in your facility. Which two actions will help you troubleshoot these coverage areas?
(Choose two.)