Which configuration would be needed to solve the problem?
Refer to the exhibit.
Refer to the exhibit. When a call between two HQ users was being conferenced with a remote
user at the BR site, the conference failed. Which configuration would be needed to solve the
problem?
How can this problem be resolved?
Refer to the exhibit.
An engineer is troubleshooting an outbound call and needs to see each step of the dial plan as it is
being parsed in the system. The engineer is not able to see all of the steps in the trace output.
How can this problem be resolved?
what might be causing this issue?
Refer to the exhibits.
The gateway CSS for inbound calls is configured using internal. CSS, which contains all the
directory number partitions for the phones. When a PSTN call that is destined for extension 2001
arrives at the MGCP gateway, the call falls. Use the debug and configuration information in the
exhibits to determine what might be causing this issue?
Which statement about the ERL is true?
Refer to the exhibit.
The output of the show call active voice command shows an ERL level of 25. Which statement
about the ERL is true?
What will occur?
Refer to the Exhibits.
Refer to the exhibits Assume that all learned SAF routes are placed in the SAF_Pt partition. An IP
phone CSS contains the following partitions in this order lnternal_Pt, 3AF_Pt When the IP phone
places a call to 3001. What will occur?
Which two troubleshooting tools would initially be the best to use when troubleshooting the PSTN gateway…
Which two troubleshooting tools would initially be the best to use when troubleshooting the PSTN
gateway side of a call routing issue while using Cisco Unified Communications Manager? (Choose
two)
which statement is true?
Refer to the Exhibit.
Assuming that the two Cisco SAF Forwarders are adjacent to each other and that no SAF clients
have been configured, which statement is true?
Which three types of information are included in an alarm?
Which three types of information are included in an alarm? (Choose three)
Which course of action should be taken to resolve this issue?
The CLI utils dbreplication reset all was run on a Cisco Unified Communications Manager.
However, replication failed to restart. Which course of action should be taken to resolve this issue?
What should the minimum bandwidth configuration on interface serial 0/1/0.121 for the command ip rsvp bandwidt
Refer to the exhibit.
The exhibit shows the output of a successful RSVP call setup that uses G.729 codec. What should
the minimum bandwidth configuration on interface serial 0/1/0.121 for the command ip rsvp
bandwidth be?